-Electronics powered via bus voltage or via USB by a connected PC -Plug onto UP 110 or UP 114 bus coupling unit -Transmission PC – USB 1.1 or higher -Electrically isolated access to the bus line via integrated socket USB (type B) -Access to all bus devices in the system The bus trasnceiver module BCU1/2 must be ordered separately. See Chapter Display and Operation Units - Pushbutton accessories.The matching desin frame must be ordered separately. See chapter Display and Operation Units.

-Electronics powered via bus voltage or via USB by a connected PC -Plug onto UP 110 or UP 114 bus coupling unit -Transmission PC – USB 1.1 or higher -Electrically isolated access to the bus line via integrated socket USB (type B) -Access to all bus devices in the system

-For communication via KNX EIB with electronic ballasts with a DALI interface -DALI output acc. to IEC 60929, for communication with up to 64 DALI ballasts -Integrated power supply with input voltage AC/DC 110...240 V, 50...400 Hz, for powering the gateway electronics and DALI output -Maximum DALI output voltage of 16 V, short circuit resistant -Green LED for displaying the operating voltage -Pushbutton for switching between bus and direct operating mode -Yellow LED for displaying direct mode -One pair of push buttons for switching On/Off of all connected DALI ballasts -One red LED in the switching button for displaying the switching state of all DALI ballasts (permanent LED light) and displaying a DALI fault condition by blinking -Control (switching, dimming, and setting dimming value) as well as feedback of status and lamp failure of up to 64 DALI ballasts -Operation of each DALI ballast either as individual device or as member of one of up to 16 DALI groups -Configurable assignment of the DALI ballasts to up to 16 DALI groups, which can only be switched and dimmed in groups including reporting status and lamp failures in groups -Control (switching, dimming, setting dimming value) of self-contained emergency luminaires as individual luminaires or as member of a DALI group -Distinction between self-contained emergency luminaires with one or two DALI devices -Starting the self-conducted testing of each individual inverter and reporting the test result via bus -Distinction between function test, short duration test, and long duration test -Optional configuration of any DALI ballast to dim to a preset dimming value in case of emergency mode -Locking of switching and dimming commands as well as configuration while emergency mode is activated -Activation of emergency mode based on a configurable number of failed DALI ballasts -Transformation of dimming commands into a temporary set point adjustment for ballasts with integrated constant light level control and directly connected light level sensor -One or two level timer -Integrated scene control for up to 16 scenes -Integrated one time or cyclical control of repeatable sequences or color effects -Possible assignment of a CIN to a DALI ballast and with commissioning of DALI ballasts and test of channel, scene, and effect functionality within ETS -Integrated bus coupling unit -Only half a standard bus load -Bus connection via bus terminal or contact system to data rail -For mounting on DIN rail EN 60715-TH35-7.5 The data rail must be ordered separately. See chapter System Products and Accessories - data rails.