-8 inputs AC/DC 12...230 V -8 relay contact outputs -Rated contact voltage AC 230 V -Rated contact operating current 16 A, p.f. = 1 -Electronics power supply via an integrated power supply unit for AC 230 V -Device functional even without bus connection or if bus voltage absent or bus communication interrupted or not yet activated -Green LED to indicate operational readiness -Push button to switch between bus and direct mode -Yellow LED to indicate direct mode activated -Push button for each output to switch the output in direct mode via a toggling function by a short actuation and for changing the output mode between remote control relay and time switch relay by holding down the push button for some seconds -1 red LED per output to indicate the switching state -1 red LED per input to indicate the current signal state -Device preset at the factory for direct switching of an output through a toggling function via the input of the same name -Selectable function for each input when using the Engineering Tool Software (ETS): -Switching status / binary value transmission -Switching, short / long operation -Single button dimming, single button sun protection control, 1-button group control (sequence control) -1-bit scene control -8-bit scene control, 8-bit value, edge-triggered, 8-bit value, short / long operation -16-bit floating point value, edge-triggered, 16-bit value, short / long operation, 16-bit value, edge-triggered, 16-bit floating point value, short / long operation -Selectable function for each pair of inputs: 2-button dimming with stop telegram, 2-pushbutton shutter/blind control -Selectable blocking / releasing of each input via a corresponding blocking object -Sending of the input objects after a change of status -Selectable logic operation (AND/OR) for one input with a further communication object and with variable start value of the logic operation at bus voltage recovery -Setting by means of the ETS, whether all outputs are to be configured identically or individually -Selectable mode for each output (normal mode, time switch mode) -Optional addition of a night mode object for each output for time-limited switching On of the output (and hence the illumination) at night -Variable On and Off delay times for each output -Variable On period in night mode or in time switch mode -Selectable warning signal prior to imminent switching-off by means of three-times short off and on switching (flashing) in night mode or in time switch mode -Status object for reporting direct mode -Optional status object per output for status reporting -Sending of status objects on request and/or automatically after a change -Integrated 8-bit scene control and linking of each output with up to 8 scenes -Selectable switching state for each output at mains or bus power failure as well as after bus or mains voltage recovery -Integrated bus coupling units with only half a standard bus load -Bus connection via bus terminal or contact system to data rail -Modular installation devices for mounting on TH35 EN 60715 mounting rail The optional data rail must be ordered separately. See chapter System Products and Accessories - data rails.
Модель: 5WG15021AB02Цена:
В корзину